In this part, you will set up the network topology and configure basic settings, such as the interface IP addresses and device name. Ethernet cables as shown in the topology Instructions Part 1: Configure Devices and Verify Connectivity.Console cable to configure the Cisco switch via the console ports.
#Mac ethernet console Pc
#Mac ethernet console manual
Instructor Note: Refer to the Instructor Lab Manual for the procedures to initialize and reload devices. Note: Make sure that the switches have been erased and have no startup configurations. Depending on the model and Cisco IOS version, the commands available and the output produced might vary from what is shown in the labs. Other switches and Cisco IOS versions can be used. Note: The switches used are Cisco Catalyst 2960s with Cisco IOS Release 15.2(2) (lanbasek9 image). You will verify your configurations by testing for network connectivity.Īfter the devices have been configured and network connectivity has been verified, you will use various commands to retrieve information from the devices to answer questions about your network equipment. You will configure the switch and PC to match the addressing table. You will cable the equipment as shown in the topology.
This lab will explore and analyze the components that make up a MAC address, and how you can find this information on a switch and a PC. This address is assigned by the manufacturer and stored in the firmware of the NIC.
0 kommentar(er)
